Wireless HDMI Transmitter and Receiver Kit - 1080P Full HD, 820ft/250M Range, 2.4/5.8GHz Dual Band, IR Support & Loop-Out - Perfect for DSLR Cameras, Projectors, Laptops in Church, Home Office & Conference Room Setups

Wireless HDMI Extender Receiver 5.8G wireless transmission with dual antenna design improves the quality and reliability of wireless HDMI signals.Easy installation, plug-and-play, no additional settings.Avoid the cost and time of installing complex and expensive wiring infrastructure.Support IR pass-back with 20-60KHzfrequency,with local loop-out function.1080P high-definition picture quality, support 1080P@60Hz high-definition resolution, support 60 times per second picture update frequency, clear and natural playback, smooth and clear picture". With the increase of RX, the wireless transmission distance will be shortened.(line of sight distance, unobstructed) 1 TX to 1 RX transmission distance: 200m; 1TX to 2 RX transmission distance: 60m; 1 TX to 3 RX transmission distance: 30m; 1 TX to 4 RX transmission distance: 20m; Support Maximum 1TX to 4RXs This wireless hdmi extender can support 1 TX to 4RXs (Max), you can add more RXs according to the quatity you need. Noted: Users need to pair themselves as needed (as picture) to allow multiple expander RXs to be used. If more RXs are needed, you can search for the B09Y1173WD to purchase, which allows up to 1 TX and 4 RXs connections. 820Ft Line Of Sight Transmission Wirelessly transmit HD signal (up to 250 m under a barrier-free environment without interference) Plug-and-play with Local Loop-out Quick and easy setup as no complicated cables or wires are required and no software has to be installed. The HDMI local output on the transmitter acts as a distributor and provides an additional output for use by the local display. IR Control Equipped IR signal extension, you can control the signal source device at the receiver and it supports IR transmissionSimply point your remote at the IR emitter included with your device to control your source A/V device. Audio Separation The AMS interface on the TX is used to collect external audio, and the sound is transmitted through the TX to the RX for play the collected sound. Installation Steps First connect the HDMI cable, the signal source connect Sender (transmitter) IN input; local display device connect Sender(transmitter) OUT output.Then connect the receiver to a remote display device (such as a television, a splicing screen and so on).IR remote control function: pay attention to the infrared head of the sender should face and close to the signal source.